KEYENCE KV Series - Manual (Page 111)

Chapter 3 Simulator
2-87
1 3
Exit procedure
File ➔ Editor (Ctrl + F1)
➔ Clear Device and Go to Editor (Ctrl + F2)
The following two methods are available to exit from the simulator and return to the
editor.
■ Returning to the editor without clearing device values
Select "Editor" from the "File" menu.
Note: When this operation is performed, the information on bus, etc. is cleared.
Therefore, when the mode is changed back to the simulator from the editor and
simulation is performed, differential type instructions, etc. may result in unexpected
operations.
■ Returning to the editor after clearing device values
Select "Clear Device and Go to Editor" from the "File" menu.
Note: You cannot exit from the ladder software itself while in simulator mode. To exit
from the ladder software, return to the editor and then select "Exit" from the "File"
menu.
KVSKA Chap 03.P65 08.3.11, 11:29 AM 87