KEYENCE KV Series - Manual (Page 120)

Chapter 3 Simulator
2-96
3
Changing the current value/preset value/attribute
To change the current value, preset value or attribute (radix, comment) of the
selected device, use the dialog bar.
The dialog bar is displayed at the bottom of the screen, and allows you to register a
device on the monitor all window and registration monitor window. To change the
current value, preset value and attribute (radix, comment), perform the following
procedure.
➮ For registration of devices, refer to “Monitor All” on page 2-109 and “Registration Monitor” on
page 2-119.
1. Select the device to be changed on the ladder monitor window.
➮ Selecting devices (p. 2-94)
The values corresponding to the selected device are displayed in the current
value box and preset value box (offered for a timer/counter only) respectively.
2. Change the radix, comment, current value and preset value using the dialog bar.
The cursor can be moved in each direction using the Tab key (in the forward
direction) and the Tab + Shift keys (in the reverse direction).
When the ENTER key is pressed, the following operation is performed.
When the cursor is placed in "Type" or "No.": Registers a new value.
When the cursor is placed in "Bit", "Radix" or "Comment": Writes a value to the
current device.
Note 1: The attribute (Comment) box is displayed on the dialog bar only when both
the monitor all and the registration monitor are active.
The attribute (Comment) box is not displayed when the ladder monitor is active.
To change the comment type displayed, select "Show Mode" from the "View" menu.
➮ Display mode (p. 2-19)
Note 2: When data which cannot be set is entered, the message "Current value is
unacceptable." is displayed.
Comment
Preset value write button Radix
Current value write button
Preset value write box
Current value write box
KVSKA Chap 03.P65 08.3.11, 11:29 AM 96