KEYENCE KV Series - Manual (Page 172)

Chapter 4 Monitor
2-148
4
4.5 Monitor All and Registration Monitor
This section briefly describes the functions of the monitor all and registration moni-
tor. For details, refer to "Chapter 3 Simulator" on page 2-83.
4.5.1 Functions of the monitor all window
Monitor all offers the following functions.
• Displays the current value and preset value of all devices, and the ON/OFF
status of the contacts and coils for each device type.
• Displays all the registered comments.
• Turns on/off bit devices.
• Changes the current value, etc. using the dialog bar.
➮ For execution and operating procedures for the monitor all window, refer to "3.4 Monitor All" on
page 2-109.
4.5.2 Functions of the registration monitor
The registration monitor offers the following functions.
• Registers up to 40 devices.
• Changes the position of registered devices.
• Displays the current values of registered devices, and the ON/OFF status of bit
devices and comments.
• Displays timing charts for registered devices (both bit devices and word devices).
• Turns on/off bit devices.
• Changes the current value, etc. using the dialog bar.
➮ For execution and operating procedures for the registration monitor, refer to "3.5 Registration Monitor"
on page 2-119.
Note: Timing charts are not actuated by a scan on the PLC side.
Only one vertical cursor is displayed on timing charts.
KVSKA Chap 04.P65 08.3.11, 11:30 AM 148