KEYENCE KV Series - Manual (Page 149)

Chapter 3 Simulator
2-125
1 3
Copying the device attribute
Edit ➔ Copy Device Attribute in Registration Monitor ★ Right-click (Copy Attribute)
Only the device attribute (bit count, radix, comment type) of another device can be
copied. This function can be used to copy only the attribute of another device while
retaining the device type and device number.
To copy the attribute, perform the following procedure.
1. Left-click the copy source device.
2. Place the cursor in the copy destination device, and right-click it. When the menu
is displayed, select "Copy Attribute".
• The attribute is copied.
Note 1: Never left-click a device when specifying the copy destination. Leftclicking
specifies the copy source.
Note 2: Step 2 can be performed by pressing the Esc key so that the cursor color
becomes the same as the title bar color. Place the cursor in the copy destination
device using the UP and RIGHT keys, and then select "Copy Device Attribute in
Registration Monitor" from the "Edit" menu.
▼
KVSKA Chap 03.P65 08.3.11, 11:29 AM 125