KEYENCE KV Series - Manual (Page 77)

Chapter 2 Editor
2-53
1 2
2. While pressing and holding the left button, move the pointer to the selection end
position (drag).
The selected range is displayed in yellow.
• Selecting the range in units of cells
While dragging the mouse pointer, move it in the horizontal direction up to the
target cell until the desired range is selected.
• Selecting the range in units of lines
While dragging the mouse pointer, move it in the vertical direction up to the target
line until the desired range is selected.
Note: A portion of a cell covering two or more lines cannot be selected.
3. Release the left button in the selection end position.
To cancel the selection, click anywhere in the ladder diagram.
■ Selecting the range using the keyboard
1. Place the cursor in the selection start position using the LEFT, RIGHT, UP and
DOWN keys.
2. While pressing and holding the Shift key, press the LEFT, RIGHT, UP or DOWN
key, and move the cursor to the selection end position.
The selected range is displayed in yellow.
Note: A portion of a cell covering two or more lines cannot be selected.
3. Release the [Shift] key in the selection end position.
To cancel the selection, press the LEFT, RIGHT, UP or DOWN key again.
Note: When the range is selected in units of cells from the right to the left, the cell at
the left end cannot be selected. When the range is selected in units of lines in an
upward direction, the line at the top end cannot be selected.
KVSKA Chap 02.P65 08.3.11, 11:28 AM 53