KEYENCE KV Series - Manual (Page 55)

Chapter 2 Editor
2-31
1 2
2.3.3 Setting automatic file save for the file
File ➔ Set Auto Save
Temporary copies of the ladder diagram, comments and labels are automatically
saved at constant intervals while you are working on the file.
When the automatic file save function is set, the file is automatically copied for a
temporary save at the specified interval. This will minimize the damage caused by
power interruptions or other accidents that may occur before you save the file.
The setup and cancellation procedures are described below.
■ Setting the automatic file save function
1. Select "Set Auto Save" from the "File" menu.
2. The "Set Auto Save" dialog box is opened. Click "Auto Save" to add the check
mark, and then enter the time interval for automatic save.
• The automatic file save function is set to every 5 minutes by default.
3. Click the [OK] button.
■ Canceling the automatic save function
1. Select "Set Auto Save" from the "File" menu.
2. The "Set Auto Save" dialog box is opened. Delete the check mark next to "Auto
Save", and click the [OK] button.
Note 1: The automatic file save function set here is applied to all the ladder program
files currently open.
Note 2: The file saved automatically is automatically erased when the Ladder
Builder for KV is closed normally. If the Ladder Builder for KV is closed abnormally,
the files saved automatically are automatically read when the Ladder Builder for KV
is started up the next time.
KVSKA Chap 02.P65 08.3.11, 11:28 AM 31