KEYENCE KV Series - Manual (Page 164)

Chapter 4 Monitor
2-140
4
2. Select "File", "Monitor" and "Convert → Transfer → Monitor" from the menu, or
click the button.
• The ladder program created by the editor is converted.
• The monitor window is displayed.
• The "Transfer Program" dialog box is displayed.
Note 1: Write is not performed when there is no difference between the program
saved in the PLC and the program transferred.
Note 2: If conversion is not performed normally, the message "Conversion error
exists. Data can’t be transferred." is displayed. When the [OK] button is clicked, the
error list is displayed. Correct the cause of error, and then transfer the program
again.
Note 3: When the code check is specified, the message "Reverse conversion error"
is displayed for the ladder containing a deconversion error. When the [OK] button is
clicked, the ladder is transferred to the PLC. However, the transferred program
cannot be read. Correct the cause of error, and then transfer the program again.
➮ H-3 Programs which cannot be decompiled (p. 2-203)
If a program is written while running, serious danger may be generated de-
pending on the status of the control equipment connected to the PLC. Pay
careful attention.
3. The program is transferred to the PLC, and the write status is indicated on the
graph.
4. When a transfer ends normally, the monitor is automatically started up.
WARNING
KVSKA Chap 04.P65 08.3.11, 11:30 AM 140