KEYENCE KV Series - Manual (Page 91)

Chapter 2 Editor
2-67
1 2
2.8 Editing the Mnemonic List
This section describes how to display each block of circuit in a ladder diagram as a
mnemonic list, and how to edit the mnemonic language directly.
2.8.1 Displaying and terminating a mnemonic list
Displaying a mnemonic list
Edit ➔ Edit List
To display mnemonic lists by specifying blocks and to enter symbols by editing
mnemonic lists, perform the following procedure.
1. Place the cursor in the block for which a mnemonic list is to be displayed or in
which the edit contents of the mnemonic list are to be inserted/replaced.
In the case of insertion, the edit contents are inserted above the cursor line.
2. Select "Edit List" from the "Edit" menu, or click the button.
The mnemonic list of the block at the cursor position is displayed on the list edit
window.
The mnemonic language can be directly edited on this screen.
For a compiled block, step numbers are displayed.
When entering a new mnemonic, a step number and comment do not have to be
entered.
➮ For the compilation procedure, refer to "2.12 Compilation" on page 2-75.
KVSKA Chap 02.P65 08.3.11, 11:28 AM 67