KEYENCE KV Series - Manual (Page 123)

Chapter 3 Simulator
2-99
1 3
4. Click the [Register] button.
The specified condition is registered, and the contents are displayed on the break
condition window.
5. When registering two or more conditions, repeat steps 2 to 4.
6. When all conditions are registered, click the [Exit] button.
The "Register Break Condition" dialog box is closed.
When the program is stopped by the break condition, the line of the condition satis-
fied is highlighted in red in the case of an OR condition, or all the lines are high-
lighted in red in the case of an AND condition.
Changing and deleting registered contents
All the registered conditions are displayed on the break condition window.
The registered contents can be changed or deleted from this window.
■ Changing the registered contents
Place the cursor over the condition to be changed, and double-click it. The "Regis-
ter/Change Break Condition" dialog box is then displayed. (See the figure above.)
Set a new break condition, and click the [Change] button. The break condition in the
line with the cursor is changed.
When first registering the condition, click the [Register] button instead.
■ Deleting the registered contents
The following three methods are available to delete the registered contents.
• Place the cursor in the condition to be changed, and then select "Delete Break
Condition" from the "Edit" menu.
• Place the cursor in the condition to be changed, and right-click it. Then, select
"Delete" from the menu displayed.
• Place the cursor in the condition to be changed, and press the Delete key.
KVSKA Chap 03.P65 08.3.11, 11:29 AM 99