KEYENCE KV Series - Manual (Page 68)

Chapter 2 Editor
2-44
2
2.4.5 Entering/Deleting connection lines
Edit ➔ Edit Connection Line (Ctrl + K + \)
Entering connection lines
The following two methods can be used to enter connection lines.
■ Pressing the keys or clicking the icon
(F8) + (/) (slash key) or
: Draws a connection line downward from the cursor
position.
(F9) + (-) (minus key) or : Draws a connection line to the right of the cursor
position.
■ Using the mouse and cursor control keys in connection line edit mode
To draw connection lines using the mouse, first change the input mode.
The following four methods can be used to change the mode.
•
Select "Edit Connection Line" from the menu displayed by right-clicking.
• Select "Edit Connection Line" from the "Edit" menu.
• Press the Ctrl and K keys at the same time.
• Press the \ key.
When connection line edit mode is selected, the cursor shape is changed as follows.
To return to the normal edit mode, perform this procedure again.
1. Place the mouse cursor at the desired connection line start position. When using
the keyboard, press the ENTER key.
2. While pressing and holding the left mouse button, move the mouse cursor in the
desired direction (drag). When using the keyboard, press either the LEFT,
RIGHT, UP or DOWN key.
3. Release the button at the desired connection line end position. When using the
keyboard, press the [ENTER] key again. (If the [Delete] key is pressed, the
connection line is deleted.)
KVSKA Chap 02.P65 08.3.11, 11:28 AM 44