KEYENCE KV Series - Manual (Page 71)

Chapter 2 Editor
2-47
1 2
4. Click and select the device for which a label/comment is to be edited, and then
click the [Edit] button. (Or the desired device displayed in the list can be clicked
and selected.)
When using the keyboard, select the desired device using the UP and DOWN
keys, and press the ENTER key.
The cursor is displayed in "Label Name" in the label/comment input area so that
characters can be entered.
5. Enter or change the label/comment. A label/comment can be copied from or
exchanged with another device.
• The table below shows the available character types and the maximum number
of characters allowed.
To register basic relays, click the [Register Basic Relay] button in the "Edit Com-
ment/Label" dialog box, and then enter the basic relays of the model used into
comment 1.
6. When input is complete, click the [Write] button.
To close the "Edit Comment/Label" dialog box, click the [Exit] button.
The label/comment is entered.
To display labels/comments, select the "View" menu. When the submenu is dis-
played, select "Show Label" or "Show Comment".
➮ For the method to specify the comment to be displayed, refer to the display mode (p. 2-19).
Note: A label name can be used instead of a device name when entering, searching
for or replacing a symbol.
For example, when the label "SW1" is attached to the device "0000", the program
can be written as follows.
Instead of entering "0000" : SW1
Instead of entering "LD0000" LD: SW1
Labels cannot be entered in the instruction selection window.
Label name Alphabet. 8 characters maximum.
Spaces and commas cannot be entered.
Comment 1 32 characters maximum
(This comment is compatible with KV IncrediWare (DOS) relay comments.)
Comment 2 32 characters maximum
Comment 3 32 characters maximum
KVSKA Chap 02.P65 08.3.11, 11:28 AM 47