KEYENCE KV Series - Manual (Page 162)

Chapter 4 Monitor
2-138
4
4.2.2 Setting the comment transfer
File ➔ Communication Setup ➔ Set Comment Transfer
Set the comment range to be transferred to the PLC.
Note 1: Make sure to set the comment range when comments are transferred along
with programs to the PLC.
Note 2: Comments can be transferred to the KV-300 and Visual KV Series only.
Comments cannot be transferred to the KV-10R(W)/T(W), KV-16R(W)/T(W), KV-
24R(W)/T(W) and KV-40R(W)/T(W)/80R(W)/T(W).
Note 3: Up to 1,000 comments can be transferred. When more than 1,000 com-
ments are set, 1,000 comments are transferred from the top of the device list.
To set the comment range to be transferred, perform the following procedure.
1. Select "File", "Communication Setup" and "Set Comment Transfer".
• The "Set Comment Write Range" dialog box is displayed.
2. Enter the range to be transferred for each device.
• When the [Auto Setup] button is clicked, all the registered comments are se-
lected.
3. To register the setting and close the dialog box, click the [OK] button. To cancel
the setting, click the [Cancel] button.
KV-300 and Visual KV Series
Only
KVSKA Chap 04.P65 08.3.11, 11:30 AM 138