KEYENCE KV Series - Manual (Page 118)

Chapter 3 Simulator
2-94
3
Selecting devices
On the ladder monitor window, the current and preset values of the selected device
can be changed. To select a device, perform the following procedure.
■ Selecting a device using the mouse
Place the mouse pointer over the device to be selected, and click it.
The cursor becomes gray to indicate that it is selected.
■ Selecting a device using the keyboard
While the cursor is green, place the cursor in the device to be selected using the
LEFT, RIGHT, UP and DOWN keys, and then press the ENTER key.
The cursor becomes gray to indicate that it is selected.
■ Changing the current value, etc.
Once a device is selected, the current value, etc. can be changed using the dialog
bar.
➮ For the procedure for changing the current value, preset value, etc. using the dialog bar, refer to
"Changing the current value/preset value/attribute" (p. 2-96).
Note: When the cursor is displayed in gray, all key operations are disabled on the
ladder monitor window. To move the cursor using the [LEFT], [RIGHT], [UP] and
[DOWN] keys or turn on/off a device using the space bar, press the [Esc] key once
to change the cursor back to green, and then perform the desired operation.
0000 0000
KVSKA Chap 03.P65 08.3.11, 11:29 AM 94