KEYENCE KV Series - Manual (Page 34)

Chapter 1 Introduction
2-10
1
1.4.2 Installation procedure
This section describes how to install the software.
The installation procedure varies depending on which Windows version you are
using. Refer to the section appropriate for your operating environment.
Installation in Windows 95 ( ➮ See below)
Installation in Windows 3.1 ( ➮ Page 2-12)
Installation in Windows 95
As an example, this section describes how to install the software in Windows95
using the following drive configurations.
Drive C: Hard disk drive
Drive D: CD-ROM drive
Note: Close all other applications before beginning installation.
1. Insert the Ladder Builder for KV master disk #1 into the floppy disk drive.
2. Click “My Computer”.
3. Click [Ladder Builder for KV] in the CD-ROM drive.
Next, click [disk 1] and then double-click [setup.exe].
4. The graph is displayed, and preparation for installation begins.
5. When the following screen is displayed, click the [Next] button. To cancel installa-
tion, click the [Cancel] button.
KVSKA Chap 01.P65 08.3.11, 11:27 AM 10