KEYENCE KV Series - Manual (Page 143)

Chapter 3 Simulator
2-119
1 3
3.5 Registration Monitor
The registration monitor displays timing charts for registered devices. When steps
are executed, the current status is displayed in real-time so that program operations
can be confirmed. This section describes how to view and manipulate the registra-
tion monitor.
3.5.1 Outline of the registration monitor
The registration monitor offers the following functions.
• Registers up to 40 devices.
• Changes the position of registered devices.
• Displays timing charts for registered devices (both bit devices and word devices).
• Displays the ON/OFF status and comments of bit devices.
• Turns on/off bit devices.
• Changes the current value, etc. using the dialog bar.
• Sets the break condition.
• Sets the scan time.
• Sets the watch dog timer.
3.5.2 Displaying, saving, and reading the registration monitor
The registration monitor registers devices and displays timing charts.
The registration monitor window in which devices are registered can be saved in a
file.
Displaying the registration monitor
File ➔ Registration Monitor
When displaying the registration monitor for the first time, display the registration
monitor window, and then register devices by dragging and dropping them from the
ladder monitor or by using the dialog bar.
➮ For the procedure for registering devices by specifying the type and number from the dialog bar, refer
to "Changing the current value/preset value/attribute" on page 2-118.
KVSKA Chap 03.P65 08.3.11, 11:29 AM 119