KEYENCE KV Series - Manual (Page 131)

Chapter 3 Simulator
2-107
1 3
Cross reference search
Edit ➔ Find Device at Cursor Position on Ladder Monitor
➔ Search Backward (F2) ★ Right-click
➔ Search Forward (F3) ★ Right-click
➔ Search for OUT Backward (Shift + F2) ★ Right-click
➔ Search for OUT Forward (Shift + F3) ★ Right-click
To perform a cross reference search means to search for a device equivalent to the
device in the current cursor position or an instruction which sets the device to OUT.
The following four search methods are available.
Search in the backward direction
Search
➔ Backward (F2) ★ Right-click
Searches for a device equivalent to the device in the current cursor position in the
area before the current position.
Search in the forward direction
Search
➔ Forward (F3) ★ Right-click
Searches for a device equivalent to the device in the current cursor position in the
area after the current position.
Search for OUT in the backward direction
Search
➔ OUT Backward (Shift + F2) ★ Right-click
Searches for an instruction which sets the device in the current cursor to OUT in the
area before the current position.
Search for OUT in the forward direction
Search
➔ OUT forward (Shift + F3) ★ Right-click
Searches for an instruction which sets the device in the current cursor to OUT in the
area after the current position.
Note 1: When the search reaches the last line or the first line, the message
"Searched to end (beginning) of program" is displayed.
Note 2: The cross reference search is available only while the ladder monitor is
active.
KVSKA Chap 03.P65 08.3.11, 11:29 AM 107