ADLINK PCI-8158 User Manual
Page 111
![background image](/manuals/733466/111/background.png)
MotionCreatorPro
101
Right play button: Clicking this button will cause the 8158
start to outlet pulses according to previous setting.
Z
In “Absolute Mode,” it causes the axis to move to posi-
tion.
Z
In “Relative Mode,” it causes the axis to move back-
wards.
Z
In “Cont. Move,” it causes the axis to start to move
according to the velocity setting, but in the opposite
direction.
Z
In “Manual Pulse Move,” it causes the axis to go into
pulse move. The speed limit is the value set by “Maxi-
mum Velocity.”
18.Stop Button: Clicking this button will cause the 8158 to
decelerate and stop. The deceleration time is defined in
“Decel. Time.” The related function is _8158_sd_stop().
19.I/O Status: The status of motion I/O. Light-On means
Active, while Light-Off indicates inactive. The related
function is _8158_get_io_status().
20.Buttons:
Z
Next Card: Change operating card.
Z
Next Axis: Change operating axis.
Z
Save Config: Save current configuration to 8158.ini And
8158MC.ini.
Z
Close: Close the menu.