ADLINK PCI-8158 - Manual (Page 32)

22 Signal Connections
Table 3-3: Output Signal
The default setting of OUT and DIR is set to differential line driver
mode.
The following wiring diagram is for OUT and DIR signals on the 2
axes.
NOTE: If the pulse output is set to open collector output mode, OUT-
and DIR- are used to transmit OUT and DIR signals. The
sink current must not exceed 20mA on the OUT- and
DIR- pins. The default setting is 1-2 shorted.
DIR3+ J12 J12
OUT4+ J5 J5
DIR4+ J13 J13
OUT5+ J6 J6
DIR5+ J14 J14
OUT6+ J7 J7
DIR6+ J15 J15
OUT7+ J8 J8
DIR7+ J16 J16
Output
Signal
For differential line driver output,
close breaks between 1 and 2 of:
For open collector output, close
breaks between 2 and 3 of: