ADLINK PCI-8158 - Manual (Page 24)

14 Installation
X P1 is for Axis 0 to 3 control and P2 is for Axis 4 to 7 control.
2.6 K1/K2 Pin Assignments: Simultaneous Start/
Stop
K1 and K2 are for simultaneous start/stop signals for multiple axes
or multiple cards.
Note: +5V and GND pins are provided by the PCI Bus power.
35 EZ1+ I Encoder Z-phase (+) 85 EZ3+ I Encoder Z-phase (+)
36 EZ1- I Encoder Z-phase (-) 86 EZ3- I Encoder Z-phase (-)
37 PEL0 I End limit signal (+) 87 PEL2 I End limit signal (+)
38 MEL0 I End limit signal (-) 88 MEL2 I End limit signal (-)
39 GDI0 I DI/LTC/PCS/SD/CLR0 89 GDI2 I DI/LTC/PCS/SD/CLR2
40 DO0 O General Output 0 90 DO2 O General Output 2
41 ORG0 I Origin signal 91 ORG2 I Origin signal
42 EXGND Ext. power ground 92 EXGND Ext. power ground
43 PEL1 I End limit signal (+) 93 PEL3 I End limit signal (+)
44 MEL1 I End limit signal (-) 94 MEL3 I End limit signal (-)
45 GDI1 I DI/LTC/PCS/SD/CLR1/EMG 95 GDI3 I DI/LTC/PCS/SD/CLR3
46 DO1 O General Output 1 96 DO3 O General Output 3
47 ORG1 I Origin signal 97 ORG3 I Origin signal
48 EXGND - Ext. power ground 98 EXGND - Ext. power ground
49 EXGND - Ext. power ground 99 E_24V - Isolation power Input, +24V
50 EXGND - Ext. power ground 100 E_24V - Isolation power Input, +24V
No. Name Function
1 +5V PCI Bus power Output (VCC)
2 STA Simultaneous start signal input/output
3 STP Simultaneous stop signal input/output
4 GND PCI Bus power ground
Table 2-2: K1/K2 Pin Assignments
No. Name I/O Function No. Name I/O Function
Table 2-1: P1/P2 Pin Assignments