ADLINK PCI-8158 - Manual (Page 112)

102 MotionCreatorPro
5.3.6 Two-Axis Operation Menu
In this menu, users can change the settings two selected axis,
including velocity mode motion, preset relative/absolute motion.
1. Motion Parameters: Set the parameters for single axis
motion. This parameter is meaningless if “Manual Pulse
Move” is selected, since the velocity and moving dis-
tance is decided by pulse input.
Z
Start Velocity: Set the start velocity of motion in units of
PPS. In “Absolute Mode” or “Relative Mode,” only the
value is effective. For example, -100.0 is the same as
100.0.
Z
Maximum Velocity: Set the maximum velocity of motion
in units of PPS. In “Absolute Mode” or “Relative Mode,”
only the value is effective. For example, -5000.0 is the
same as 5000.0.