Doremi IMS1000 - Manual (Page 133)

IMS.OM.002949.DRM Page 133 of 320 Version 1.7
Doremi Labs
12.6 Trigger Cue Tab
A Trigger Cue allows for the execution of a Macro Automation Cue upon the occurrence of an
event from an external device using a Signal or General Purpose Input. When the user selects
an event to occur from the external device, the occurrence of that event “triggers” a Macro
Automation Cue. The Macro Automation Cue will then be executed. Both the event and the
Marco Automation Cue are defined during the Trigger Cue creation.
The user can access the Trigger tab by either selecting it on the left had side of the GUI under
the Macro Editor tab (Administration → Macro Editor) or by clicking on the Trigger Cue arrow in
the Macro Automation tab and Quick Controls tab (Figure 146).
Note: The Signal comes from an external device connected over the Ethernet. The external
device options are: eCNA, JNior, and Raw.
Example: If a Trigger cue is based on the event, “Wait for GPI #1 ON,” it is possible to link a
specific Macro Automation Cue as presented above in order to be executed when GPI #1 is ON.
12.6.1 Trigger Cue Tab Overview
Figure 147: Macro Editor - Trigger Cue Tab
12.6.2 Trigger Cue Creation
The Trigger Cue tab is located under Administration
→ Macro Editor → Trigger Cue (Figure
147). Alternatively, the user may also click on the green arrow button on the right side of the
Automation Cue tab to access the Trigger Cue tab (Figure 146).
● To create a new Trigger Cue, click the New Trigger button (Figure 147).
New
Trigger
Button