Doremi IMS1000 - Manual (Page 268)

IMS.OM.002949.DRM Page 268 of 320 Version 1.7
Doremi Labs
15 Drive Replacement
This section presents the procedure to apply when a drive needs to be replaced.
15.1 Degraded Drive
 The Storage tab will display the failed drive in Storage Details telling the user that the
drive needs to be replaced and will present you with the RAID status.
To replace the drive, follow the steps below:
15.1.1 Removing the Old Drive
 Press on the handle to release it and open the handle all the way.

Slide the drive out gently from the HDD enclosure (Figure 334).
Figure 334: HDD Removal
15.1.2 Reboot
Reboot the unit with just the two functioning drives in place.
15.1.3 Inserting a New Drive
 Before inserting the drive, press on the handle to release it and open it all the way until it
clicks.

Insert the new drive all the way in the HDD enclosure at the same position as the
previous drive.
CAUTION: The drive must be inserted all the way inside the HDD enclosure BEFORE trying to
close the handle. Otherwise the drive might not be plugged properly.
 Close the handle by pushing it toward the HDD until it clicks.
 When the new drive insertion process has been completed, the drive will automatically
start rebuilding.