Comtech EF Data CDM-570 - Manual (Page 275)

CDM-570/570L Satellite Modem with Optional IP Module Revision 12
Ethernet IP Module - CLI and Telnet Operation MN/CDM570L.IOM
14–5
Selection Entry Description
Working Mode W*
-or-
C**
Sets the Working Mode.
*For IP Module V1 Firmware Ver. 1.7.# and later / IP Module V2
Firmware Ver. 2.2.# and later:
• Managed Switch
• Router – Hub
• Router – Remote
• Router – Point to Point
** For IP Module Firmware Ver. 1.6.# and earlier / IP Module V2
Firmware Ver. 2.1.# and earlier:
• Router – Small Network
• Router – Large Network
• Router – Point to Point
• Managed Switch
See Chapter 13 for additional information.
Working Mode is disabled when Brouter Mode VLAN
Filtering is enabled. If selection is attempted while
configured as such, the following error message displays:
“Can’t change Modem Working Mode when
Brouter VLAN Filter is Enabled”
Managed Switch
Multicast Option
(For Modem Firmware
Ver. 1.5.4 and later; was
“easyConnect Multicast
Option” for Modem
Firmware Ver. 1.5.3.6 and
earlier)
E
If both units have this feature enabled, when unit is running in Managed
Switch mode, Multicast is only forwarded across link.
Header comp refresh rate
(in pkts) for UDP/RTP1
H
Allows for the adjustment of how often to send a full header of this type of
traffic when Header Compression is enabled. Header comp refresh rate
(in pkts) for UDP
U
Header comp refresh rate
(in pkts) for all others
O
Payload comp refresh
rate (in pkts)
Q
Allows for the adjustment of how often to send a full payload when Payload
Compression is enabled.
Telnet Timeout T
Determines how many minutes (1-60) of Telnet inactivity before the Telnet
session is automatically terminated.