Comtech EF Data CDM-570 - Manual (Page 395)

CDM-570/570L Satellite Modem with Optional IP Module Revision 12
Appendix E MN/CDM570L.IOM
E–9
E.5.1 IP Commands and Queries
E.5.1.1 Admin Commands and Queries
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments for
Command or
Response to Query
Description of Arguments
Response to
Command
Query
(Instruction Code
and Qualifier)
Response to
Query
System Working
Mode SWM= 1 byte, value of 0
through 1 Command or Query, where:
1=Router-Small Network
2=Router-Large Network
3=Router-Point to Point
4=Router-Vipersat
5=Managed Switch
Router-Vipersat mode needs the ViperSat option to be available on the modem.
Changing the address/working mode may reboot the modem. SWM=
SWM!
SWM? SWM =x
(see description of
arguments)
Managed Switch
Multicast Option EMO= 1 byte, value of 0 or
1 Command or Query, where:
0=Disabled
1= Enabled
Enables or disabled forwarding of multicast traffic while in Managed Switch mode.
Valid only when in Managed Switch mode on 570.
EMO =
EMO!
EMO? EMO =x
(see description of
arguments)
Header
Compression
Refresh rate –
UDP/RTP1 HRR= 3 bytes Command or Query.
Header compression refresh rate, 1 to 600
Resolution=1 packet
Refresh rate for UDP/RTP1 streams.
Example: HRR=50
Restrictions: 570 only HRR =
HRR!
HRR? HRR =xxx
(see description of
arguments)
Header
Compression
Refresh rate –UDP HRU= 3 bytes Command or Query.
Header compression refresh rate, 1 to 600
Resolution=1 packet
Refresh rate for UDP only stream.
Example: HRU =50
Restrictions: 570 only HRU =
HRU!
HRU? HRU =xxx
(see description of
arguments)