Comtech EF Data CDM-570 - Manual (Page 326)

CDM-570/570L Satellite Modem with Optional IP Module Revision 12
Ethernet IP Module - CLI and Telnet Operation MN/CDM570L.IOM
14–56
Selection Entry Description
Filtered – Flow Correlator
[RO] Packet are filtered due to improper establishing SAT-to-SAT traffic (This
counter generally is seen on outbounding Hub modem in point-to-multipoint
setup)
Filtered – Management
Path
Not used.
Filtered – WAN Scaling Internal Error occurred during WAN scaling sub process in processing packet.
Filtered – Ping Ping packets were received but PING feature was disabled.
Filtered – Access Control
Packets are received while “Access List” control is enabled but IP address
does not match the access list database.
Filtered – Vipersat MCP Internal Error occurred while processing Vipersat Multi-command messages.
Filtered – Vipersat UCP Internal Error occurred while processing Vipersat Uni-command messages.
Filtered – Codeload Internal error occurred while processing Codeload messages.
Filtered – Multicast A multicast packet is received but no application is associated with it.
Filtered – Bad Packet Malformed packet is received. This may be due to internal or external error.
Filtered – Route
Applies to Vipersat Remote only – when a packet is received from the WAN
and the Route Table contains a route to transmit that packet to the WAN, the
packet is filtered to prevent a routing loop.
Filtered – Vipersat
Remote
Packet filtered due to QoS Rule configured to filter.
Filtered – QoS Rule Packet filtered due to QoS Rule configured to filter.
Filtered – Vipersat Loop
Packet are filtered due to Vipersat loop
(a modem configured as a Vipersat Remote Expansion unit and default route
set to 0.0.0.0/0).
Filtered – Bad Header Len Filtered due to packets received with less than 14 bytes of L2 header.
Filtered – Bad Data Ptr Internal error occurred while accessing the packet data.
Filtered – MAC Split Err Not currently used.
Filtered – L3Type Err Not currently used.
Filtered – Local
Destination
Packet received with destination MAC as modem MAC and destination IP is
not modem IP while modem is operating in bridge mode (Managed Switch)
Filtered – Redundancy Err
Applies to Offline modem in 1:1 Redundancy
Packets are received on the WAN port by the both Offline unit and Online unit,
only Online unit is allowed to forward the packets. Indicates packets received
by Offline unit from WAN port that were filtered because unit is Offline.
Filtered – ICMP Filter
This is the same as “Filtered Ping”, except this will update in Managed Switch
mode.
Filtered – Port Err
Non-IP or ARP packets are targeted to End-station. (End-station will not allow
any non-IP packets).
Filtered – Per port route
rule
In 1:1 Redundancy Managed Switch mode – a packet received with modem
destination MAC, but the IP does not match the traffic IP or management IP.
In Router mode – per port WAN filtered mode is ON.
Filtered – Total Total Filtered Packets