Comtech EF Data CDM-570 - Manual (Page 97)

CDM-570/570L Satellite Modem with Optional IP Module Revision 12
Front Panel Operation MN/CDM570L.IOM
5–11
(CONFIG: Remote Control) Ethernet: SNMP Æ Traps Æ
Community
Trap Community: (◄ ►,▲ ▼)
comtech
To edit the SNMP Trap Read or Write Community strings: First, use the ◄ ► arrow
keys to select a character to edit, and then use the ▲ ▼ arrow keys to edit that
character. Note that only the first 20 characters on the bottom line are available.
All printable ASCII characters are available with the exception of the backslash ‘/’
(ASCII code 92) and tilde ‘~’ (ASCII code 126).
Press ENTER once the string is composed – all trailing spaces are removed from the
string upon entry.
(CONFIG: Remote Control) Ethernet: SNMP Æ Traps Æ
Version
Trap Version:
SNMPv1 SNMPv2 (◄ ►,ENT)
Use the arrow keys to select the SNMP Trap Version (SNMPv1 or SNMPv2), and
then press ENTER.
(CONFIG: Remote Control) Ethernet: SNMP Æ Traps Æ IP
Addr#1
or Addr#2
Trap IP #X: (◄ ►,▲ ▼)
000.000.000.000
(Where ‘X’ indicates Trap IP #1 or Trap IP #2) To edit the Trap Destination IP
Address: First, use the ◄ ► arrow keys to select a digit to edit, then use the ▲ ▼
arrow keys to edit the value of that digit.
If both Trap IP Addresses are 000.000.000.000, this designates the
Traps as disabled.
5.2.2.1.2 CONFIG: All
All = Stop
(Stop, Start) (◄ ►,▲ ▼)
Use of this menu branch is highly recommended for new users, as it provides guidance through
the modem’s configuration in its entirety. Use the ▲ ▼ arrow keys to select between Stop and
Start – the menu then presents every individual configuration option screen in sequential fashion.
For each successive menu, use the ◄ ► arrow keys to first select, and then the ▲ ▼ arrow keys
to edit, the various parameters.