Installation – Hypertherm HT2000-200 Volt User Manual

Page 140

Advertising
background image

OPERATION: ARGON-HYDROGEN MANIFOLD

HySpeed HT2000

Instruction Manual

7-3

19

Installation

WARNING

Before operating the argon-hydrogen manifold, turn all power and gases connected

to the HT2000 OFF.

Follow the installation and operation procedures before turning power and gases ON.

Argon-Hydrogen Cable – Argon-Hydrogen Manifold to Power Supply (PS)

A. Connect the receptacle end of the argon-hydrogen cable (Fig. 7-3) to

Cable Connection Point

on the

argon-hydrogen manifold. (Fig.7-2)

B. Connect the other end of the cable to TB4 (smaller terminal strip on the inside rear panel of the power

supply). Match up wires 102, 103, 13 and 14 to wires already connected to the strip. Connect the two

shield wires to points labeled as PE (protective earth).

Argon-Hydrogen supply to Argon-Hydrogen Manifold

A. Attach one end of the supply hosing to the argon/hydrogen supply tank or regulator, and attach the other

end to the

Argon-Hydrogen Supply Hose Connection

on the manifold. (Fig. 7-2)

Figure 7-2

Argon-Hydrogen Manifold Connection Points

Cable Connection Point

Plasma Gas
Torch Lead
Connection

Argon-Hydrogen
Supply Hose
Connection

Advertising
This manual is related to the following products: