Hypertherm HT2000-200 Volt - Manual (Page 6)

Changed Page Description IM246 Rev 4 to 5 7/11/97
0.01 Uprevved to 5 because of new valve in RHF console
4.07 New graphic of RHF console
6.13 Eliminated 40A cutting chart for mild steel
6.16 Eliminated 40A cutting chart for mild steel
6.17 Added to note on 020679 swirl ring use
7.05 Rewording minutia
8.04 Added power supply cleaning routine maintenance
8.05 Bumped page
9.09 Changed 003138 from 100A to 20A
9.20 New graphic of RHF console
9.21 New part number for SV7
10.01 Uprevved wiring diagrams to MM
Begin w/serial # 2000-003196
Changed Page Description IM246 Rev 3 to 4 4/14/97
0.01 Uprevved to 4 for additional cables, hoses, new wiring dia., note to 50A cutting
0.06 Added figures to TOC
0.07 Added figures to TOC
2.05 Added tolerances to gas pressures
2.07 Corrected one dimension for gas console
3.02 Reference to Section 2 for gas specs, added caution
3.03 Reference to Section 2 for gas specs
3.10 Changed view of power cable connections to match label
4.06 Referenced to section 9 for additional lengths of hoses and cables
5.03 Added tolerances to gas pressures
6.10 Added tolerances to gas pressures
6.17 Added note to cut chart for using 020679 swirl ring
6.19A Added note to 50A cut chart about possible cut degradation from N2 in the lines
6.39 Added note to cut chart for using 020679 swirl ring
7.07 Added tolerances to gas pressures
8.03 Referenced torch coolant draining procedure
8.26 Added torch coolant draining procedure
9.38 Additional lengths
9.39 Additional lengths
9.40 Additional lengths
9.41 Additional lengths
9.42 Additional lengths
9.43 Additional lengths
9.44 Additional lengths
9.45 Additional lengths
9.46 Additional lengths
9.47 Additional lengths
10.01 Uprevved wiring diagrams to KK
Begin w/serial # 2000-003090