Hypertherm HT2000-200 Volt - Manual (Page 8)

Changed Page Description IM246 Rev 1 to 2 12/20/96
0.01 Uprevved manual due to LVD compliance
0.03-0.08 Updated table of contents
1.01-1.04 New Safety section
1a.01-1a.04 New French Safety section
2.02 Changed reference from 380-415V CE to 400V CE
2.05 Changed reference from 380-415V CE to 400V CE
3.04 Changed warning on propylene glycol to not induce vomiting
3.05 Added specs for 400V
3.06 Added specs for 400V
3.08 Changed figures of transformers to show new configurations
3.09 Changed figures of transformers to show new configurations
3.10 Changed reference from 380-415V CE to 400V CE
5.03 Added "See Status Indicators Before Startup to step 6
6.01 Added STATUS Indicators Before Startup to Sect. 6 TOC
6.02 New STATUS logic
6.03 Added STATUS Indicators Before Startup
6.10 Added "See Status Indicators Before Startup to step 6
7.07 Added "See Status Indicators Before Startup to step 7
8.03 Added 6-month maintenance to power supply
8.04 New figure for cleaning pump strainer
8.05 Bumped page
8.06 New startup logic
8.09 Picture of new power distribution board
8.11 Changed logic of cause 3.3
8.15 New STATUS logic
8.16 New STATUS logic
8.17 New STATUS logic
8.18 New STATUS logic
8.20 Removed reference to old chopper temperature switch
8.21 New graphic of control board
8.22 Changed figure label to Rev. G error codes (no change in actual codes)
8.23 New STATUS logic
8.24 New STATUS logic
9.05 Changed firmware rev level to G
9.06 Changed part no. for PCB5, corrected description of items 3 and 9
9.07 Changed reference from 220-380-415V to 220-380-400-415V
9.09 New part no. for PCB1; changed reference to 220-380-400-415V on T1
9.13 New chopper part no. and temp switch
9.19 New coolant reservoir part no.; added part nos. for gauge, drain valve
9.29 Changed part no. of potentiometer
9.51 Changed part nos. of PCB1, CH1
10.01 Uprevved wiring diagrams to GG
Begin w/serial # 2000-002500