NewTek 3Play 4800 - Manual (Page 60)

Page | 44
4.3 CHANNEL AND SOURCE DELEGATES
7. Press A on the Control Surface to set the current Channel Delegate.
Note: See Section 8.1 (Dual Channel Replay) for details of 3Play’s A and B channels.
8. Press LIVE to set the Source Delegate – see Section 8.3.
9. Hold down the ANGLE button, push 3 on the number pad, and release the ANGLE
button to delegate the live source from 3Play’s input 3 to Channel A.
10. Push B on the Control Surface to change the Channel Delegate to B.
11. Press LIVE again, to set the Source Delegate for Channel B – note that outputs have
independent Source Delegates.
12. Hold down ANGLE again and push 1 to delegate input 1 to Channel B.
4.4 RECORD
13. Watching Channel B, push the STOP button on the Control Surface. Hmmm, that didn’t
seem to work. Let’s try something else.
14. Pull the T-Bar to about the middle of its stroke. Still watching Channel B? See anything
happen? No.
Why did playback ignore our Control Surface operations and continue at normal speed? This is
because we did not first enable recording. Stopping (or jogging) the Speed of a LIVE source
would automatically kick playback into Delayed playback - if it could. However, this requires
3Play to be recording.
Let’s try all of those steps again, after enabling recording. Remember that Speed (for Channel B)
is still set to around 5o% (Channel A is still be at the default speed, 100%)
15. Press the red REC (Record) button on the Control Surface, to enable capture.