HP 30 HP30 - Manual (Page 137)

Chapter 6 - Parameter Description [I/O]
6-45
Setting Range
LCD 7-Seg
Description
Lost Command 11 Lost command detection
Run 12 Inverter running detection
Stop 13 Inverter stop detection
Steady 14 Steady speed detection
INV line 15
COMM line 16
Exchange signal outputs
Ssearch 17 Speed search mode detection
Step pulse 18 Step detection in Auto mode
Seq pulse 19 Sequence detection in Auto mode
Ready 20 Inverter ready detection
Trv. ACC 21 Traverse acceleration frequency
Trv. DEC 22 Traverse deceleration frequency
MMC 23 Used for MMC operation
Zspd Dect 24
0 Rpm detection signal during vector
control
Torq Dect 25
Torque detection signal during vector
and sensorless control.
[FDT-1]
When the output frequency reaches the reference
frequency (target frequency), AXA-AXC terminal is
CLOSED.
[AXA-AXC configured as ‘FDT-1’]
[FDT-2]
AXA-AXC is CLOSED when the reference frequency is in
I/O-43 [FDT Bandwidth] centered on I/O-42 [FDT
Frequency], and the output frequency reaches I/O-43
centered on I/O-42.
[AXA-AXC configured as ‘FDT-2’]
[FDT-3]
AXA-AXC is CLOSED when the output frequency reaches
the band centered on the FDT frequency. The output is
OPENED when the output frequency goes outside the FDT
bandwidth centered on the FDT frequency.
[AXA-AXC configured as ‘FDT-3’]
[FDT-4]
AXA-AXC is CLOSED when the output frequency reaches
the FDT frequency. The output is OPENED when the
output frequency goes below the FDT bandwidth centered
on the FDT frequency.
AXA-AXC CLOSED
Output Frequency
Time
Time
I/O-43 / 2
I/O-42
Reference Frequency
AXA-AXC CLOSED
Output Frequency
Time
Time
I/O-43 / 2
Reference Frequency
AXA-AXC ON
Output Frequency
Time
Time
I/O-43 / 2
ON
I/O-42