HP 30 HP30 - Manual (Page 38)

Chapter 2 - Operation
2-10
2.4 Operation Method
The ACtionMaster has several operation methods as shown below.
Operation Method Function Function Setting
Operation using Keypad Run/Stop command and frequency are set only through the
keypad. DRV 03: Keypad
DRV 04: Keypad-1 or -2
Operation using
Control Terminals Closing FX or RX terminal performs Run/Stop.
Frequency reference is set through V1 or I or V1+I terminal. DRV 03: Fx/Rx-1 or -2
DRV 04: V1 or I or V1+I
Run/Stop is performed by the keypad.
Frequency reference is set through the V1 or I or V1+I
terminal. DRV 03: Keypad-1 or -2
DRV 04: V1 or I or V1+I Operation using both
Keypad and Control
Terminals
Closing FX or RX terminal performs Run/Stop.
Frequency reference is set through the keypad. DRV 03: Fx/Rx-1 or -2
DRV 04: Keypad-1 or -2
Operation using
Option Boards Operation using option board.
The ACtionMaster has five option boards and three sub-
boards.
Option Boards: RS485, Device-Net, F-Net, ProfiBus and
ModBus
Sub-Boards: Sub-A Board, Sub-B Board, Sub-C Board and
Sub-D Board. Please refer to ‘Chapter 7 -
Options’ for more
information.