HP 30 HP30 - Manual (Page 44)

Chapter 3 - Quick-Start Procedures
3-4
3.3 Operation using Keypad and Control Terminals
3.3.1
Frequency set by External Source and Run/Stop by Keypad
1. Install a potentiometer on terminals V1, VR, 5G and connect wiring as shown below left.
When a ‘4 to 20mA’ current source is used as the frequency reference, use terminals I and 5G as shown below right.
2. Apply AC power.
3. LCD: Press [▲] key to move DRV 03.
7-Seg: Rotate encoder knob until ‘03’ is
displayed.
4. LCD: Press [PROG] key.
7-Seg: Press [PROG/ENT] key.
5. LCD: Press [▲] key one time.
7-Seg: Rotate encoder knob and set at ‘0’.
6. LCD: Press [ENT] key.
7-Seg: Press [PROG/ENT] key.
7. Confirm that the DRV 04 is set at ‘V1’.
8. Press [SHIFT/ESC] key.
Set the frequency by rotating the potentiometer.
9. LCD: Press [FWD] or [REV] key.
7-Seg: Press [RUN] key.
P1 P2
JOG CM
P3 FX RX NC
CM BX RST I
VR VI
FM 5G
4 to 20mA signal
1 ㏀, 1/2 W
P1 P2
JOG CM
P3 FX RX NC
CM BX RST I
VR VI
FM 5G
DRV 04 must be set at V1. DRV 04 must be set at I.
DRV
►T/K 0.0 A
00 STP 0.00Hz
The DRV LED is ON.
DRV ► Drive mode
03 Fx/Rx-1
DRV
► Drive mode
03 Fx/Rx-1
The PROG/ENT LED is turned ON.
DRV ► Drive mode
03 Keypad
The PROG/ENT LED is turned ON.
DRV ► Drive mode
03 Keypad
The PROG/ENT LED is turned OFF.
DRV
► Freq mode
04 V1
The PROG/ENT LED is turned ON.
DRV
►T/V 0.0 A
00 STP 60.00Hz
The FWD or REV LED starts blinking. The RUN LED starts blinking.
To change the motor running
direction, change DRV 13 to ‘1’.