HP 30 HP30 - Manual (Page 67)

Chapter 5 - Parameter List
5-7
Keypad Display Setting Range
Code Description
LCD 7-Segment LCD 7-Segment
Units
Factory
Default
Adj.
During
Run
Page
FU2-27
Delay Time
Before Auto Restart
Retry Delay 27 0 to 60 [sec] 0.1 1.0 [sec] Yes 6-2
FU2-28 Speed Search Hold Time SS blk time 28 0 to 60 [sec] 0.1 1.0 [sec] No 6-2
0.75kW 0
1.5kW 1
2.2kW 2
3.7kW 3
5.5kW 4
7.5kW 5
11.0kW 6
15.0kW 7
18.5kW 8
FU2-30 Rated Motor Selection
Motor select 30
22.0kW 9
- 18 No
FU2-31 Number of Motor Poles Pole number 31 2 to 12 1 4 No
FU2-32 Rated Motor Slip Rated-Slip 32 0 t o10 [Hz] 0.01 No
FU2-33
Rated Motor Current
(RMS)
Rated-Curr 33 1 to 200 [A] 1 No
FU2-34
No Load Motor Current
(RMS)
Noload-Curr 34 0.5 to 200 [A] 1 No
FU2-36 Motor Efficiency Efficiency 36 70 to 100 [%] 1
19
No
FU2-37 Load Inertia Inertia rate 37 0 to 1 1 0 No
6-2
FU2-38 Carrier Frequency Carrier freq 38 1 to 15 [kHz] 1 5 [kHz] Yes 6-2
V/F 0
Slip comp 1
Sensorless_S 2
Sensorless_T 3
Vector_SPD 4
FU2-39 Control Mode Selection Control mode 40
Vector_TRQ 5
- V/F No 6-2
No 0
All 1
Rs + Lsigma
Enc Test
FU2-40 Auto Tuning Auto tuning 41
Tr
- No No
FU2-41 20
Stator Resistance of
Motor
Rs 42 0 to (depending on FU2-30) [ohm] 0.001 No
FU2-42
Leakage Inductance of
Motor
Lsigma 44 0 to (depending on FU2-30) [mH] 0.001
21
No
6-2
18 The rated motor is automatically set according to the inverter model name. If different, set the motor capacity connected.
19 This value is automatically entered according to the rated motor set in FU2-30. If different, set the correct value of the motor.
20 Code FU2-41 through FU2-46 appears only when FU2-39 is set to ‘Sensorless_X’ or ‘Vector_XXX’.
21 This value is automatically entered according to the rated motor set in FU2-30. If different, set the correct value of the motor.