Powerware 9390 UPS 100160 kVA - Manual (Page 136)

COMMUNICATION
EATON Powerware ® 9390 UPS (20–80 kVA) Installation and Operation Manual S 164201603 Rev 2 www.powerware.com 12-2
Relay Interface Card
Modbus Card
Multi-Server Card
Modem Card
Single-Port Card
ConnectUPS-X Web/SNMP Card
Power Xpert ® Gateway Card
Figure 12‐1. Optional X-Slot Cards
12.2 Powerware LanSafe Power Management Software
Each Powerware 9390 UPS ships with Powerware LanSafe Power Management
Software. To begin installing Powerware LanSafe software, see the instructions
accompanying the Software Suite CD.
Powerware LanSafe software uses an RS-232 serial link to communicate with the
UPS. The software provides up-to-date graphics of UPS power and system data and
power flow, a complete record of critical power events, and notification of important
UPS or power information. With custom views for monitoring status and metering
information, various user groups can select the most useful view for their specific
needs.
12.3 Remote Notification
For connection and setup of a modem, or to enable Remote Notify and Call Home
features within the UPS, please contact Eaton (see page 1-7).
Remote Notification provides the UPS with the capability to use a standard
off‐the‐shelf PC modem as a telephone interface. The features provided by this option
are:
S
Call a remote terminal or pager based on programmable events and alarms
S
Four separate, programmable notification groups (phone numbers)
S
Automatic answering (user-configurable) for access to the Terminal mode of
the UPS
S
Remote and local ability to clear Call Out alarms and events
S
Error detection and correction for misconfigured and disconnected modems.
Remote Notification provides the user with the option of receiving alarms and notices
at a remote location. Using the Terminal mode, the user calls the UPS to perform
basic monitoring. In the event of a UPS alarm or notice, the user is notified at the
remote location. The UPS calls through the modem to the user's computer or pager
and leaves a message.
Remote Notification is an extension of the Terminal mode with the additional support
algorithms necessary to control an external modem. Connection to the UPS is made
when a user calls the UPS on the phone. The user has exactly the same capabilities
as if using a terminal connected directly to an RS-232 port.