Powerware 9390 UPS 100160 kVA - Manual (Page 25)

UPS INSTALLATION PLAN AND UNPACKING
EATON Powerware ® 9390 UPS (20–80 kVA) Installation and Operation Manual S 164201603 Rev 2 www.powerware.com 3-3
W A R N I N G
The UPS cabinet is heavy (see Table A on page A-3). If unpacking instructions are not closely followed, the
cabinet may tip and cause serious injury.
C A U T I O N
S
Do not install a damaged cabinet. Report any damage to the carrier and contact your Eaton service
representative immediately.
S
Do not tilt the UPS cabinet more than 10° from vertical or the cabinet may tip over.
To unpack the cabinet:
1. Carefully inspect the outer packaging for evidence of damage during transit.
2. Use a forklift or pallet jack to move the packaged cabinet to the installation site,
or as close as possible, before unpacking. Insert the forklift or pallet jack forks
between the pallet supports on the bottom of the unit.
NOTE Verify that the forklift or pallet jack is rated to handle the weight of the cabinet (see Table A on
page A-3 for cabinet weight).
3. Set the pallet on a firm, level surface, allowing a minimum clearance of 3m (10 ft)
on each side for removing the cabinet from the pallet.
NOTE The UPS cabinet is shipped with a debris shield covering the ventilation grill on top of the unit. Do
not remove the debris shield until installation is complete.
4. Remove the protective covering from the cabinet.
5. Remove the packing material, and discard or recycle in a responsible manner.
6. Inspect the contents for any evidence of physical damage, and compare each
item with the Bill of Lading. If damage has occurred or shortages are evident,
contact your Eaton service representative immediately to determine the extent of
the damage and its impact upon further installation.
NOTE While waiting for installation, protect the unpacked cabinet from moisture, dust, and other harmful
contaminants. Failure to store and protect the UPS properly may void your warranty.