Powerware 9390 UPS 100160 kVA - Manual (Page 28)

INSTALLING THE UPS SYSTEM
EATON Powerware ® 9390 UPS (20–80 kVA) Installation and Operation Manual S 164201603 Rev 2 www.powerware.com 4-2
NOTE Verify that the forklift or pallet jack is rated to handle the weight of the cabinet (see Table A on
page A-3 for cabinet weight).
2. Unfasten the front door latch and swing the door open (see Figure 4‐1).
3. Remove the door. Remove the retaining screw located inside the door at the
bottom hinge pivot point, then lift the door off. Retain the hardware for later use.
4. If the leveling feet are not fully retracted, turn the leveling feet until they are
retracted.
5. Remove three bolts securing the rear shipping bracket to the cabinet and two
bolts securing the bracket to the pallet (see Figure 4‐2 on page 4-4). Remove
the rear shipping bracket. If installing the cabinet permanently, retain the
shipping bracket and securing hardware for later use.
6. Remove three bolts securing the front anti‐tip/shipping bracket to the cabinet and
two bolts securing the bracket to the pallet (see Figure 4‐1). Remove the front
anti-tip/shipping bracket. Retain the front anti-tip/shipping bracket and securing
hardware for later use. Do not discard the front anti-tip/shipping bracket. This
bracket is required for installation.
7. Remove three bolts securing the removable skid and remove the skid (see
Figure 4‐2 on page 4-4).