IDEC FL1E SmartRelay - Manual (Page 109)

Programming IDEC SmartRelay
IDEC SmartRelay Manual 95
Defining a specific analog output value
To output a specific analog value at the two analog outputs:
9. Move the ’>’ cursor to ’Defined’:
Press or
10.Confirm ’Defined’: Press OK
The display shows:
AQ1: 00.00
AQ2: 00.00
11.Enter a specific output value for each of the two analog
outputs.
12.To confirm your entry: Press OK
3.6.12 Defining the type of analog outputs
Analog outputs can be either 0..10V/0..20mA, which is the
default, or 4..20mA.
To define the type of analog outputs, follow these steps
starting from the programming menu:
1. Move the “>” cursor to ’Edit..’:
Press or
2. Select ’Edit’: Press OK
3. Move the “>” cursor to ’AQ’: Press or
4. Select ’AQ’: Press OK
5. Move the “>” cursor to ’AQ type’: Press or
6. Select ’AQ type’: Press OK
IDEC SmartRelay shows the following display, for example:
AQ1:default
AQ2:4..20mA
The defined type for each analog channel is shown. To
change the type, continue as follows
7. Move to the AQ

that you want to change. Press or
8. Select either default (0..10V/0..20mA) 
or 4..20mA. Press or
9. Confirm your selection. Press OK