IDEC FL1E SmartRelay - Manual (Page 340)

IDEC SmartRelay without display
326 IDEC SmartRelay Manual 
Operating characteristics
IDEC SmartRelay is ready for operation when power is
switched on. Switching off an IDEC SmartRelay without
display is equivalent to disconnecting the power supply, e.g.
as if you were removing the plug.
The circuit program of FL1E-B12... versions cannot be
started or stopped by means of buttons. This is why the
FL1E-B12... versions have other startup characteristics:
Startup characteristics
If there is no circuit program in IDEC SmartRelay or on the
inserted memory cartridge or combined memory/battery
cartridge, IDEC SmartRelay remains in STOP.
If there is a valid circuit program in IDEC SmartRelay
memory, the IDEC SmartRelay automatically switches from
STOP to RUN when power is switched on.
The circuit program on an inserted memory cartridge or
combined memory/battery cartridge is automatically copied
to IDEC SmartRelay, immediately after power is switched
on. The existing circuit program in IDEC SmartRelay
memory is overwritten. The system automatically changes
from STOP to RUN.
Provided the PC cable is connected to IDEC SmartRelay,
you can download the circuit program to IDEC SmartRelay
and start it by means of WindLGC PC software (see Chapter
7.1).
Operating status indication
Operating states, e.g. Power On, RUN and STOP are
indicated by an LED on the front hood.
• Red LED:
Power On/STOP
• Green LED: Power On/RUN
The red LED is lit after Power On and in all IDEC SmartRelay
states other than RUN. The green LED is lit when IDEC
SmartRelay is in RUN mode.