IDEC FL1E SmartRelay - Manual (Page 42)

IDEC SmartRelay installation and wiring
28 IDEC SmartRelay Manual 
Removal
To remove IDEC SmartRelay:
....... if you have installed only one IDEC SmartRelay base
module:
Part
A
1. Insert a screwdriver into the eyelet at the bottom of the
slide interlock and move the latch downward.
2. Swing the IDEC SmartRelay base module off the DIN rail.
1
2
1
2
3
4
A B
....... if you have connected at least one expansion
module to IDEC SmartRelay base module:
Part
B
1. Using a screwdriver, push the integrate slide interlock to
the right.
2. Slide the expansion module off towards the right.
3. Insert a screwdriver into the eyelet at the bottom of the
slide interlock and lever it downward.
4. Swing the expansion module off the profile rail.
Repeat steps 1 to 4 for all other expansion modules.
Note
If you have connected more than one expansion module, it is
advisable to start removal with the last module at the right-hand
side.
Make sure the slide interlock of the module to be installed/removed
is not engaged in the next module.