IDEC FL1E SmartRelay - Manual (Page 265)

IDEC SmartRelay memory and battery cartridge (card)
IDEC SmartRelay Manual 251
Assigning a security function
To assign a circuit program and copy protection function to
the memory cartridge or combined memory/battery
cartridge, open the programming mode and select “Card”.
1. Switch IDEC SmartRelay to programming mode (ESC /
>Stop).
2. Select the ’Card’ command: Press or
3. To apply ’Card’: Press OK
4. Move the ’>’ cursor to ’CopyProtect’: Press or
5. To apply ’CopyProtect’: Press OK
IDEC SmartRelay shows the following display:
>No
Yes
CopyProtect:
No
The current protection setting is shown in the bottom line.
This function is disabled by default (”No“: disabled).
Enabling the security function
To set the security function:
1. Move the ’>’ cursor to ’Yes’:
Press or
2. Confirm ’Yes’: Press OK
IDEC SmartRelay shows the following display:
>No
Yes
CopyProtect:
Yes
Note
This only generates a circuit program and copy protection for the
memory cartridge or combined memory/battery cartridge; the circuit
program itself must be copied separately from IDEC SmartRelay to
the memory cartridge or combined memory/battery cartridge. (This
copy can be done at power-on. See chapter 6.4).
You can always change the “No” status (security function disabled)
to “Yes” (security function enabled).
A status change from “Yes” (security function enabled) to “No”
(security function disabled) is only possible if the memory cartridge
or combined memory/battery cartridge does not contain a circuit
program.