IDEC FL1E SmartRelay User Manual
Page 29
Getting started with IDEC SmartRelay
IDEC SmartRelay Manual
15
Marine certification requires the surge protective device what
manufactured by DEHN+SÖHNE GmbH+Co., in a case of
12/24V DC or 24V DC power line. The required Type No. and
Part No.: BVT AD 24, 918 402. See Note on page 298.
For further information, see our Internet address
✔
ID for Australia
Recycling and Disposal
IDEC SmartRelay units can be fully recycled, due to their
low-pollutant equipment. Contact a certified electronic waste
disposal center for environmentally acceptable recycling and
disposal of your old devices.
Our products carrying the label shown at the side are compliant
with AS/NZS 2064:1997 (Class A) standard.
!
Warning
Risk of death, personal injury or property damage can occur if you
do not follow safety precautions for hazardous locations.
In potentially explosive atmospheres, do not disconnect
connectors when the system is in RUN. Always switch off the
power supply to IDEC SmartRelay and its components before you
disconnect any connectors or components.
Substitution of components can impair suitability for Class I,
Division 2 locations. Combinations of equipment are subject to
investigation by the local authority having jurisdiction at the time of
installation.