IDEC FL1E SmartRelay - Manual (Page 221)

IDEC SmartRelay functions
IDEC SmartRelay Manual 207
5. To change to the start state: 
Press or
6. To change the start state: 
Press or
B33 +/
On/Off
Start=Off The status is not retentive
“Switch” function
Q is reset in the init cycle after the
program start
7. Confirm your entries with 
OK
View in parameter assignment mode (example):
Here, you can set or reset the ’Switch’ parameter (On/Off).
When in RUN, IDEC SmartRelay shows the following
display:
B33
Switch=Off
Let us assume you want to set ’Switch’ (On).
1. Change to the editing mode:

Confirm with OK 
(the cursor is now positioned on ’Off’)
2. To change from ’Off’ to ’On’: 
Press or
3. Confirm your entries with 
Press OK
B33
Switch=On
The momentary pushbutton/switch
is here switched on