Anritsu 682XXB - Manual (Page 122)

10. In the Properties window, make the following se-
lections:
Bits per second 19200 (See Note)
Data bits 8
Parity None
Stop bits 1
Flow control Xon / Xoff
11. After making the selections, click on the OK but-
ton.
12. Press <ENTER> on the keyboard.
13. Verify that the
$
prompt appears on the PC dis-
play.
14. This completes the initial setup for calibration.
4-12 682XXB/683XXB MM
CALIBRATION INITIAL SETUP
NOTE
When calibrating instruments with
operating firmware below Version
2.00, set the Bits per second rate to
9600. (This does not apply to
682X5B/683X5B models.)