Fire-Lite MS-9200UDLSC Addressable Fire Alarm Control Panel - Manual (Page 105)

MS-9200UDLS Series Manual — P/N 52750:H 4/14/2014 105
Master Programming Level Programming
Annunciators
Pressing 1 while viewing the Options Screen will cause the control panel to display the following
screens:
An LCD-80F Terminal Mode annunciator, ACS BUS annunciator, or ANN-BUS
annunciator/module can be installed in the MS-9200UDLS system. Refer to “Guidelines” on
page 22 for rules governing the use of various annunciator types. Do not use a mix of ACS
annunciators and ANN annunciators since they use different communication protocols. ACS or
ANN annunciators use the same TB9 terminal block connection. To install any of these devices,
press the number corresponding to the desired device shown in the Annunciator Screen.
 Term Options
While viewing the Annunciators screen, each press of the 1 key for Term Enabled, will cause the
display to toggle between Term Enabled No and Term Enabled Yes.
Notes:
1. The LCD-80F is a Terminal Mode annunciator. To enable the MS-9200UDLS for LCD-80F
operation, press 1 for Term Enabled Yes.
2. The Terminal Mode annunciator (LCD-80F) and the Printer/PC use the same TB8 terminal
block on the MS-9200UDLS main circuit board. Only one device can be connected at one
time, therefore, enabling an annunciator in the Term Option will disable any Printer/PC com-
munications.
 ACS Options
Pressing 2 for ACS Options while viewing the Annunciators screen, will display the following
screen:
Pressing 1 while viewing the ACS Options screen will cause the display to toggle between ACS
Enabled Yes and ACS Enabled No. To install an ACS annunciator, the display must read ACS
Enabled Yes.
If ACS has been enabled, press 2 while viewing the Annunciator Screen to select addresses for the
ACS annunciators. The following screen will be displayed:
Pressing the down arrow key will allow the programmer to view additional screens displaying
Addresses 1 -31. Each screen will indicate if an address has been used for an installed ACS
annunciator. To select one or more addresses for the installed ACS annunciator(s), press the
number key corresponding to the address in each screen. The display for the selected address will
change from No to Yes. Each press of the number key will cause the display to toggle between No
and Yes. The address of each installed annunciator must be enabled to allow communication
between the FACP and annunciator.
ANNUNCIATORS
1=TERM ENABLED NO
2=ACS OPTIONS
3=ANN-BUS OPTIONS
ANNUNCIATORS
1=TERM ENABLED
2=ACS OPTIONS
3=ANN-BUS OPTIONS
Annunciator Screen
ACS OPTIONS
1=ACS ENABLED NO
2=ACS INSTALLED
ANNUNCIATOR
1=ADDRESS 1 YES
2=ADDRESS 2 NO
3=ADDRESS 3 NO
ACS Installed Screen