Fire-Lite MS-9200UDLSC Addressable Fire Alarm Control Panel - Manual (Page 41)

MS-9200UDLS Series Manual — P/N 52750:H 4/14/2014 41
Optional Module Installation Installation
NO NC C NC NO C
TB5 TB9 TB8 TB6 TB10
PH15
PRI. PHONE LINE SEC. PHONE LINE
PH16
J12
SW1
J5 J6
JP3
4XTM
Xmt Rcv Dtr Gnd
A B
In+ In- Out+ Out- + -
A B B+ A+ B- A- A B
Slc Slc Slc Slc Shield
J7
Figure 2.17 4XTMF Connectors to MS-9200UDLS Connectors
J5 & J6 Connectors
Cut Jum
per JP3
Standoff Standoff
4XTMF
FACP main circuit board
9
2
u
d
ls
c
4
x
tm
.w
m
f
NOTE: Jumper JP2 on the FACP main circuit board can be used to configure the FACP
supervisory relay for operation with the 4XTMF module. Relay 3 at TB5 must be programmed as
a supervisory relay.
Cutting JP2 will allow the 4XTMF to generate a trouble if the supervisory contact opens
Leaving JP2 in will prevent generation of a trouble if the supervisory contact opens.