Fire-Lite MS-9200UDLSC Addressable Fire Alarm Control Panel - Manual (Page 169)

169 MS-9200UDLS Series Manual — P/N 52750:H 4/14/2014
Appendix B: Default Programming
The following table provides a list of the programming options and their factory default settings.
Program Option Factory Default Program Option Factory Default
Detector Programming Not Installed Relay 1 Alarm
Detector Type Smoke-Photo Relay 2 Trouble (fixed)
Detector Verification Off Relay 3 Supervisory
Detector Walktest Yes Annunciator Terminal Mode No
Detector PAS No Annunciator ACS Mode No
Detector Presignal No UDACT No
Detector Zone Assign. 000 only ACS Installed No
Detector Adj/Noun none Onboard DACT No
Module Programming Not Installed Printer-PC No
Module Type Monitor Printer Baud 9600
Module Walktest Yes Service Terminal Panel ID 0000
Module Presignal No Ring Count 0
Module Zone Assign. 000 only Primary Phone Type Touchtone
Module Adj/Noun none Secondary Phone Type Touchtone
Zone 0 Enable Enabled DACT Communication OFF
Zone 1 Enable Enabled AC Loss Delay 2
Zone 2 Enable Enabled Backup Reporting First Available
Zone 3 Enable Enabled Primary Reporting Style Report Point
.........................through.......... ..................... Secondary Reporting Style Report Point
Zone 96 Enable Enabled Primary Account Code 0000
Zones 97, 98 & 99 Enabled Secondary Account Code 0000
Loop Style Style 4 Primary 24 Hour Test Time 0100
Loop Protocol LITESPEED Secondary 24 Hour Test Time 0200
Trouble Reminder Off Primary Phone Number
Banner Secondary Phone Number
Time Format 12 Hr Primary DACT Format Ademco Contact ID
Hours Setting 12 Secondary DACT Format Ademco Contact ID
Minutes Setting 00 ANN-Primary Enabled No
Second Settings ANN-Primary Modules Addr. 1 - 8 None
AM-PM Setting AM ANN-Secondary Enabled No
Month Setting 01 ANN-Secondary Modules Addr. 1 - 8 None
Day Setting 01 ANN-S/PG Port
Year Setting 00 ANN-S/PG Baud 9600
Daylight Savings Enabled ANN-S/PG Data Bits 7
Month Start Daylight Savings March ANN-S/PG Parity Even
Week Start Daylight Savings Week 2 ANN-S/PG Stop Bits 1
Month End Daylight Savings November ANN-S/PG Offline Timer 60
Week End Daylight Savings Week 1 ANN-S/PG Printer Supervision No
Verification OFF ANN-80 Piezo Enabled Yes
PAS Timer 0 ANN-80 Lock Enabled Yes
Presignal Timer 0 ANN-80 Acknowledge Button Enabled Yes
Waterflow Retard Timer 0 ANN-80 Silence Button Enabled Yes
NAC 1, 2, 3 & 4 Enable Enabled ANN-80 Reset Button Enabled Yes
NAC 1, 2, 3 & 4 Silenceable Yes ANN-80 Drill Button Enabled Yes
NAC 1, 2, 3 & 4 Type Bell ANN-I/O Point/Zone Zone
NAC 1, 2, 3 & 4 Sync Type System Sensor ANN-I/O Range 00-29
NAC 1, 2, 3 & 4 Autosilence 0 ANN-I/O Active LEDs Only
NAC 1, 2, 3 & 4 Coding Steady ANN-RLY Relay 1 Zone 1
NAC 1, 2, 3 & 4 Zones Zone 000 only ................through....................... ............
NAC 1, 2, 3 & 4 Silence Inhibit No ANN-RLY Relay 10 Zone 10
Canadian Option Enabled No ANN-LED Point/Zone Zone
Waterflow Silenceable No ANN-LED Alarms/ATS (Alarm, Trbl, Supv) ATS
MNS Override No ANN-LED Range 0 - 9