Fire-Lite MS-9200UDLSC Addressable Fire Alarm Control Panel - Manual (Page 25)

MS-9200UDLS Series Manual — P/N 52750:H 4/14/2014 25
Getting Started Product Description
LDM Series Lamp Driver Modules (Graphic Annunciator)
The LDM Series Lamp Driver Modules, which consist of the LDM-32F master and LDM-E32F
expander modules, are used to provide an interface to a custom graphic LED annunciator.
Legacy ACM-8RF Relay Control Module
The ACM-8RF module provides eight Form-C relays with contacts rated for 5 amps. The
ACM-8RF mounts in the lower right corner of the FACP backbox using the ACM-8RF-BRKT
mounting bracket, also allowing space for batteries.
1.8 Getting Started
The following is a brief summary of the minimal steps involved in bringing an MS-9200UDLS on-
line:
• Install Backbox and Main Circuit Board (refer to “Mounting the Backbox” on page 28)
• Address and Install Intelligent Devices (refer to the SLC Wiring Manual)
• Enter Autoprogramming (refer to “Autoprogram” on page 66)
• Resolve Programming Conflicts
• Go to Point Program to Enter Specific Data (refer to “Point Program” on page 67). Use the
right and left arrow keys to navigate between devices.
1.9 Telephone Requirements and Warnings
1.9.1 Telephone Circuitry
Ringer Equivalence Number (REN) = 0.0B
AC Impedance: 10.0 Mega Ohm
Complies with FCC Part 68
Mates with RJ31X Male Connector
Supervision Threshold: loss of phone line voltage for 2 minutes
The REN is used to determine the quantity of devices which may be connected to the telephone
line. Excessive RENs on the telephone line may result in the devices not ringing in response to an
incoming call. In most, but not all areas, the sum of the RENs should not exceed five (5.0). To be
certain of the number of devices that may be connected to the line as determined by the total RENs,
contact the telephone company to determine the maximum REN for the calling area.