Avaya P580 - Manual (Page 171)

Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, Version v5.3.1 4-41
Using VLANs, Spanning Tree, Hunt Groups, and VTP Snooping
7. Repeat steps 1 through 10 on the switch at the other end of the
hunt group connection.
8. Select Configuration from the Modules & Ports folder on
the Web Agent window. The Module Information window
re-opens (see Figure 4-20).
9. Select a port number from the Ports column. The Physical
Port Configuration window opens (see Figure 4-21).
10. Select a checkbox from the Enable column for that port. The
group can now function as a load-sharing connection.
11. Click APPLY to save your changes, or CANCEL to restore
previous settings.
* Note: If thousands of addresses have been learned on a port
and a link in the hunt group goes down, the switch-over
of traffic between ports may take several seconds.
* Note: If you use static VLAN binding and hunt groups, make
sure to first bind all the VLANs to all the ports that you
will use in the hunt group and then apply the hunt
group to those ports.
Creating Hunt
Groups Using
the CLI
To create a hunt group using the CLI, enter the following command
from Configure mode:
<configure># set huntgroup <huntgroup-name>
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, Version 5.3 for details about this
command.