Avaya P580 - Manual (Page 711)

Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1 A-9
Upgrading the Application Software
Figure A-186. System Reset Web Page
3. Select Yes in response to the question, Do you want to
reset the switch?
The switch resets and loads the new application software.
CLI Command
To reset the switch after downloading new application software, use
the following CLI command:
<configure># reset
For more information on this command, see Chapter 27, “System,”
in the Command Reference Guide for the Avaya P550R, P580, P880, and
P882 Multiservice Switches
Resetting the Standby Supervisor
In the previous procedure "Resetting the Active Supervisor," the
procedure forces the Active Supervisor to the Standby mode and the
Standby Supervisor to the Active Supervisor mode. To recover back
to the original state, with both supervisors running new code, reset
the current Active supervisor module.